FastCAL 3000 is a high temperature blackbody source with a capacity to produce high temperature using high emissivity emitter(graphite tube) and at the same time stabilize at the required temperature within a few minutes. It is mainly used to calibrate non-contact temperature sensors. Step change in temperature is achievable within seconds. The graphite tube has an emitter diameter of 25mm (1.00″) and an emissivity of +0.99. Target temperature is sensed by a non contact temperature sensor/Pyrometer which gives a feedback to PID controller to regulate the cavity temperature precisely to the desired set points. Remote set point is achieved via RS-232 C communication port. All safety features to protect equipment and operator are easily accessible.
| Model | Fastcal 3000 |
|---|---|
| Download | Datasheet |
| Temperature Range | 500°C to 2700°C |
| Temperature Resolution | 0.1°C |
| Purge Gas | Argon gas flow with 7-10 LPM respective |
| Controlling Sensor | Pyrometer |
| Method of Control | PID controller Eurotherm make 3504 (Option - HMI & Data Logging) |
| Emissivity | 0.99 |
| Heating Time | Approx 5 Minute from 500 to 2700°C |
| Ambient Temperature | 10°C to 50°C |
| Power Requirement | 440V,Single Phase AC 50/60 Hz 50 KW |
| Dimensions | 1700mm(H) x 900mm(W) x 1200mm(D) |
| Cavity | Graphite Dual cavity blackbody, one cavity is control and one cavity for measurement |
| Heating Aperture | 25mm |
| Weight | 300 Kg |
Safety Interlock Features
System will switch off in case of :